Citizen Systems iDP-3530 User Manual
Page 26
iDP-3530 User’s Manual
CITIZEN
26
9. Initial Setting
Following are automatically set after Power-on.
(1) Printer head returns to its start position.
(2) SELECT (ON-LINE) or DESELECT (OFF-LINE) status may be chosen by the Dip Switches for Pre-Setting.
(3) Print buffer is cleared.
(4) Standard character mode is set.
(5) 66 lines per page is set.
(6) The first line set at the present line.
(7) Designation of Red printing is cleared.
(8) For 7 bit data, character code SI is applied.
10. Maintenance
10-1 Maintenance Procedures
It is recommended that users perform periodic cleaning of their printer.
(1) Exterior
The exterior case of the printer can be cleaned with alcohol. Care should be taken to keep water from reaching the
electronic parts and the printing mechanism.
(2) Interior
There is no particular requirement, however, when the printer case is opened to change settings etc., dust and
other foreign matter may be removed from the printer mechanism and circuit boards with a soft brush.
Special care should be taken to avoid damage to electronic parts and wiring. Furthermore, be sure to disconnect
the power plug from the electric outlet before opening the printer case.