Crimestopper Security Products RS-1604TW1 - Manual (Page 20)

SETTING THE CLOCK (2-WAY- LCD REMOTE)
RS-1704 TW1
1. Press the Recall button #5 on the side of the remote control 5 times.
2. The remote will beep and the AM or PM display will begin flashing.
3. Press the Lock button #1 to increase time.
4. Press the Unlock button #2 to decrease time.
5. Press the Trunk button #3 to go to the next item – AM - PM - Hour - Minutes.
6. Press the Start button #4 to Disable or Enable Beep.
7. Press the Recall button #5 to Exit Setup or wait 7 seconds, the LCD light will turn off.
RS-1804FM/1905FM
1. Press and hold all 4 buttons of remote control for approximately 3 seconds until remote beeps.
2. The minute display will begin flashing. Use the lock and unlock button to change the minute up or down to the correct time
and then press button #3 (Trunk) to set the minute value.
3. The hour display should begin flashing. Use the lock and unlock button to change the hour up or down to the correct AM or
PM hour.
4. Once the correct time is displayed, wait 6 seconds, the remote will beep twice and the time of day is set.
www.crimestopper.com
[email protected]
© 2005 Crimestopper Security Products
ONLINE TECHNICAL SUPPORT
http://www.crimestopper.com