Dell OptiPlex 7010 (Mid 2012) - Manual (Page 32)

Installing The Front Thermal Sensor
1. Secure the thermal sensor to the chassis front.
2. Thread the thermal-sensor cable into the chassis clips.
3. Connect the thermal-sensor cable to the system board.
4. Install the hard drive.
5. Install the front bezel.
6. Install the cover.
7. Follow the procedures in After Working Inside Your Computer .
Removing The Power Switch
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the
a. cover
b. front bezel
3. Press in and lift to release the power-switch cable from the system board.
32