Dell XPS/Dimension XPS Gen 3 - Manual (Page 45)

2. Reset the current CMOS settings:
a. Locate the 3-pin CMOS jumper (CLR CMOS) on the system board .
b. Remove the jumper plug from pins 2 and 3.
c. Place the jumper plug on pins 1 and 2 and wait approximately 5 seconds.
d. Replace the jumper plug on pins 2 and 3.
3. Close the computer cover .
4. Connect your computer and devices to electrical outlets, and turn them on.
Back to Contents Page
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.