Drive door, Removing the front led board, Removing the drive door – Dell XPS/Dimension XPS Gen 3 User Manual
Page 34

Removing the Front LED Board
1.
Follow the procedures in "
Before You Begin
."
2.
.
3.
Disconnect the LED cable from the system board.
4.
Remove the screw.
5.
Gently move the board upward, tilt the top of the board away from the case to release it from the three front LED board guides, and then draw the
board away from the case.
To replace the front LED board, perform the
in reverse.
Drive Door
Removing the Drive Door
CAUTION:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of
your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
1.
Open the drive door.