Dell Vostro 320 (Mid 2009) - Manual (Page 24)

Back to Contents Page
System-Board Shield
Dell™ Vostro™ 320 Service Manual
Removing the System-Board Shield
NOTE: You may need to install Adobe® Flash® Player from Adobe.com to view the following illustrations.
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the front panel .
3. Remove the internal panel .
4. Remove the I/O cover .
5. Remove the hinged stand .
6. Remove the optical drive .
7. Remove the back cover .
8. Remove the back metal-shield .
9. Remove the screw that secures the system-board shield to the computer.
10. Rotate the computer 90-degrees.
11. Remove the screws that secure the system-board shield to the side of the computer.
12. Remove the inverter board cable from the routing on the system-board shield.
13. Lift the system-board shield from the computer.
Replacing the System-Board Shield
To replace the system-board shield, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: While installing the system-board shield, ensure that you carefully route all the cables away from the shield.