Dell OptiPlex 9020 All In One (Mid 2013) - Manual (Page 19)

Installing the Optical Drive
1. Place the optical-drive bracket on the optical drive.
2. Tighten the screws that secure the optical-drive bracket to the optical drive.
3. Align and slide the optical drive into its slot.
4. Connect the optical-drive cable.
5. Tighten the screws that secure the optical drive to the computer.
6. Install the:
a) back cover
b) VESA stand
7. Follow the procedures in After Working Inside Your Computer .
Removing the Hard Drive
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the:
a) VESA stand
b) back cover
c) VESA mount bracket
3. Unthread the cables from the notches on the hard-drive bracket. Disconnect the hard-drive cables from the hard
drive.
4. Remove the screw that secures the hard-drive bracket to the system board. Slide and lift the hard-drive bracket
away from the computer.
19