Creating an s2d partition for windows nt, Creating an s2d partition for windows nt -6 – Dell Inspiron 2000 User Manual
Page 62

4-6
Dell Inspiron 2000 System Reference and Troubleshooting Guide
11. To check the size of the S2D file, at an MS-DOS prompt type
$ and
press
12. If you need to delete the S2D file, at an MS-DOS prompt type
$
$ and press
% +1 # 0 "
#"
# $
To restore the default boot sequence, perform the following steps:
1.
Turn on or restart the computer.
2.
Press
program.
If you wait too long and the operating system begins to load into memory, let the
computer complete the load operation. Then shut down the computer and try
again.
3.
Enter the Boot screen, and press
4.
Press
#/, %2 &
NOTE: The following procedure assumes that your hard-disk drive is unpartitioned and
unformatted or you have a minimum of 150 MB of unpartitioned space on the drive.
For information on partitioning and formatting your drive, see both your operating sys-
tem and your drive documentation.
To create the S2D file for computers running Microsoft Windows NT, perform the fol-
lowing steps:
1.
Insert the Dell System Software CD into the CD-ROM or DVD-ROM drive.
2.
Turn on or restart the computer.
3.
Press
program.
If you wait too long and the operating system begins to load into memory, let the
computer complete the load operation. Then shut down the computer and try
again.
4.
Enter the Boot screen, select ATAPI CD-ROM Drive, and move it to the first
position in the boot sequence.
5.
Press
The computer restarts and automatically begins to run the Dell Diagnostics.
6.
Type
to exit to MS-DOS mode.