Dell S520 Projector - Manual (Page 8)

8
17. Attach sensor cover by snapping clips over
screen frame. Secure to frame by screwing down
into the upper channel of the screen frame with
supplied #8 x 3/4” screw (Figure 10).
18. In between the projector mount and the IR sensor
cover, cable clips will be mounted to the wall for
cable management. Attach clips to the wall using:
Wood studs: (4) supplied #8 x 1” screws.
Concrete wall or no studs: (4) supplied #8-10
wall anchors and (4) supplied #8 x 1” screws.
When secure, route cables and cords behind the
two cable cover clips. Attach cable cover to the
cable clips (Figure 11).
19. Install projector mount covers and projector.
Refer to the S520 Dual Stud Wall Mount
(MSP-DCCUST1) manual.
Figure 12
Figure 10
Figure 11
Installation (continued)