Battery, Replacing the power supply, Replacing the battery – Dell Dimension 3100/E310 User Manual
Page 38
5.
Slide the power supply approximately 1 inch towards the front of the computer.
6.
Lift the power supply up and out of the computer.
Replacing the Power Supply
1.
Slide the power supply into place.
2.
Replace the screws that secure the power supply to the back of the computer frame.
3.
Reconnect the DC power cables.
4.
Connect the AC power cable to the connector.
5.
Run the cables underneath the clips, and press the clips to close them over the cables.
6.
Replace the
computer cover
.
7.
Connect your computer and devices to electrical outlets, and turn them on.
Battery
Replacing the Battery
1 release button
2 power supply
3 screws (4)
4 AC power connector
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug the cable into the computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.