Mouse problems – Dell OptiPlex FX160 (Late 2008) User Manual
Page 56
Other software problems
Check the software documentation or contact the software manufacturer for troubleshooting information —
l
Ensure that the program is compatible with the operating system installed on your computer.
l
Ensure that your computer meets the minimum hardware requirements needed to run the software. See the software documentation for information.
l
Ensure that the program is installed and configured properly.
l
Verify that the device drivers do not conflict with the program.
l
If necessary, uninstall and then reinstall the program.
Back up your files immediately
Use a virus-scanning program to check the hard drive, floppy disks, CDs, or DVDs
Save and close any open files or programs and shut down your computer through the Start menu
Memory Problems
If you receive an insufficient memory message —
l
Save and close any open files and exit any open programs you are not using to see if that resolves the problem.
l
See the software documentation for minimum memory requirements. If necessary, install additional memory (see
Memory
).
l
Reseat the memory modules (see
Memory
) to ensure that your computer is successfully communicating with the memory.
l
Run the Dell Diagnostics (see
).
If you experience other memory problems —
l
Reseat the memory modules (see
Memory
) to ensure that your computer is successfully communicating with the memory.
l
Ensure that you are following the memory installation guidelines (see
Memory
).
l
Ensure that the memory you are using is supported by your computer. For more information about the type of memory supported by your computer,
see
Memory
.
l
Run the Dell Diagnostics (see
).
Mouse Problems
Check the mouse cable —
l
Ensure that the cable is not damaged or frayed and check cable connectors for bent or broken pins. Straighten any bent pins.
l
Remove any mouse extension cables, and connect the mouse directly to the computer.
l
Verify that the mouse cable connector is seated properly.
Restart the computer —
1.
Simultaneously press
2.
Press , press the up- and down-arrow keys to highlight Shut down or Turn Off, and then press
3.
After the computer turns off, reconnect the mouse cable.
4.
Turn on the computer.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.