Dell 4310WX Projector User Manual

Page 45

Using Your Projector

UDIO

NPUT

—

Select the Audio input source, options are: Audio-A, Audio-

B, Audio-C, HDMI and DisplayPort.

OLUME

—

Press

to decrease the volume and

to increase the volume.

PEAKER

—

Select On to enable speaker. Select Off to disable speaker.

UTE

—

Allows you to mute the sounds for audio input and audio output.

OWER

ETTINGS

—

Select and press

to activate power settings. The power

settings menu consists of the following options:

OWER

AVING

—

Select Off to disable Power Saving mode. By default, the

projector is set to enter power saving mode after 120 minutes of no activity.

A warning message appears on screen showing a 60-second countdown

before switching to power saving mode. Press any key buttons during

countdown period to stop power saving mode.
You can also set a different delay period to enter power saving mode. The

delay period is the time you want the projector to wait without an input

signal. Power saving can be set to 30, 60, 90, or 120 minutes.
If an input signal is not detected during the delay period, the projector

turns off the lamp and goes into power saving mode. If an input signal is

detected within the delay period, the projector automatically turns on. If

an input signal is not detected within two hours during power saving mode,

the projector switches from Power Saving mode to Power Off mode. To

turn on the projector press the Power button.
Q

UICK

HUTDOWN

—Select Yes to turn off the projector with a single press of

the Power button. This function allows the projector to quick power off

with an accelerated fan speed. Slightly higher acoustic noise is expected

during quick power off.

NOTE:

Before you turn on the projector again, wait for 60 seconds to allow the

internal temperature to stabilize. The projector will take a longer time to turn on

if you try to power on immediately. Its cooling fan will run at full speed for about

30 seconds to stabilize the internal temperature.