Clearing cmos settings – Dell Dimension 9150/XPS 400 User Manual
Page 30
System Setup: Dell Dimension 9150 Service Manual
file:///T|/htdocs/systems/dim9150/en/sm/syssetup.htm[10/31/2012 7:59:07 AM]
2. Locate the 3-pin password jumper (PSWD) on the system board, and remove the jumper plug from pins 1 and 2.
3. Place the jumper plug on pins 2 and 3.
.
5. Connect your computer and monitor to electrical outlets, and turn them on.
6. After the Microsoft® Windows® desktop appears on your computer, shut down the computer.
7. Turn off the monitor and disconnect it from the electrical outlet.
8. Disconnect the computer power cable from the electrical outlet, and press the power button to ground the system
board.
9. Open the
10. Reattach the password jumper (PSWD) to pins 1 and 2 to re-enable the password feature.
.
NOTICE:
To connect a network cable, first plug the cable into the network port or device and then plug it into the
computer.
12. Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Settings
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in the
Product Information Guide.
1. Follow the procedures in "
2. Reset the current CMOS settings: