Cognitive Solutions C SERIES User Manual

Page 59

1 0 5 - 1 6 9 - 0 3

The output from the self test is described in the table below.

Setting

Description

Example (Actual settings may vary
from examples listed below)

Firmware version and date

FW: 195-170-140 V1.40

S/N

Printer serial number

S/N: P012345678

RAM, FLASH

RAM and FLASH size

RAM=16 MB, FLASH=8 MB

Inches Printed

Total inches printed

Inches Printed: 2911

Printhead

Printhead Designation

Printhead: KPC108_8T0A1

Printer Settings

Aux. Power

Enable 5vdc output through Serial port.

Aux. Power: OFF

Buffer Reset (1/10sec)

Enables or disables the buffer reset timer. Buffer Reset (1/10sec): 65535

Comm

Communications port configuration values
(Baud, Parity, Data Bits, Stop Bits)

Comm: 9600,N,8,1,OFF

Darkness

Darkness setting of printer. First number is
factory setting (not user modifiable).
Second number is the variable, user
modifiable setting.

Darkness: 0 (0)

Energy Offset

Adjusts the Energy Density.

Energy Offset: 0 (0)

Feed Speed

Speed at which media is fed using the
FEED button.

Feed Speed : NORMAL

Index Enabled

Current state of Indexing. Either enabled
or disabled (No Index).

Index Enabled

Feed Type

Current Indexing mode. GAP, BAR or
Notch.

Feed Type: GAP

DTBAR

Index sensor settings for Black Bar
indexing in Direct Thermal print mode.

DTBAR: R=56 T=13 G=0

TTBAR

Index sensor settings for Black Bar
indexing in Thermal Transfer print mode.

TTBAR: R=50 T=15 G=0

DTGAP

Index sensor settings for Gap indexing in
Direct Thermal print mode.

DTGAP: R=1 T=16 G=0

TTGAP

Index sensor settings for Gap indexing in
Thermal Transfer print mode.

TTGAP: R=1 T=40 G=0

DTNOTCH

Index sensor settings for Notch indexing in
Direct Thermal print mode.

DTNOTCH: R=20 T=5 G=0

TTNOTCH

Index sensor settings for Notch indexing in
Thermal Transfer print mode.

TTNOTCH: R=50 T=1 G=0

No Media (inches)

Distance (in inches) the label travels
before the printer either attempts to
recalibrate, or errors out with a red ready
light. (Gap indexing mode only)

No Media (inches): 1

Pitch (dots)

Print density in dots per inch

Pitch (dots): 200

Present Label

When ON, Printer will advance and
reverse the distance specified below for

Present Label: ON