beautypg.com

Power supply, Removing the power supply – Dell Inspiron 535 (Early 2009) User Manual

Page 29

background image

Back to Contents Page

 

Power Supply

Dell™ Inspiron™ 535/537/545/546 Service Manual 

  

Removing the Power Supply

  

Replacing the Power Supply

 

Removing the Power Supply

 

1.

Follow the procedures in

Before You Begin

.


 

2.

Remove the computer cover (see

Removing the Computer Cover

).


 

3.

Disconnect the DC power cables from the system board and the drives.

Note the routing of the DC power cables underneath the tabs in the computer chassis as you remove them from the system board and drives. You must
route these cables properly when you replace them to prevent them from being pinched or crimped.

 

4.

Remove all the cables from the securing clip on the side of the power supply.

 

5.

Remove the four screws that attach the power supply to the back of the computer chassis.

Inspiron™ 535/537

Inspiron 545/546

WARNING:

Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage on www.dell.com at the following location:
www.dell.com/regulatory_compliance.

WARNING:

To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.

WARNING:

Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)

removed.

1 power supply retention snap 2 screws (4)

3 power supply

4 voltage selector switch