Drives, Removing a hard drive – Dell Inspiron 535 (Early 2009) User Manual
Page 16

Back to Contents Page
Drives
Dell™ Inspiron™ 535/537/545/546 Service Manual
Removing a Hard Drive
1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
Disconnect the power cable and the data cable from the hard drive.
4.
Remove the four screws securing the hard drive.
5.
Slide the drive out towards the back of the computer.
6.
If removing the hard drive changes the drive configuration, ensure that you reflect these changes in system setup (see
System Setup
).
7.
Replace the computer cover (see
Replacing the Computer Cover
).
8.
Connect the computer and other devices to an electrical outlet.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING:
To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
WARNING:
Do not operate your equipment with any cover(s) (including computer covers, bezels, filler brackets, front-panel inserts, etc.)
removed.
CAUTION:
If you are replacing a hard drive that contains data that you want to keep, back up your files before you begin this procedure.
NOTE:
If you are not replacing the hard drive at this time, disconnect the other end of the data cable from the system board and set it aside. You
can use the data cable to install a hard drive at a later time.
NOTE:
The location and number of SATA connectors may vary based on your computer model. For more information, see
System Board
Components
.
1 screws (4) 2 power cable
3 data cable 4 SATA connector (on the system board)
CAUTION:
Ensure that you do not scratch the screw holes with the screwdriver as the hard disk circuit board assembly is exposed here.