Dell SE197FP Monitor - Manual (Page 5)

Monitor Specifications
General
Model number SE197FP
Flat Panel
Screen type Active matrix - TFT LCD
Screen dimensions 19 inches (19-inch diagonal viewable image size)
Preset display area:
Horizontal 376.3 mm (14.8 inches)
Vertical 301.1 mm (11.8 inches)
Pixel pitch 0.294 mm x 0.294 mm
Viewing angle Viewing angle 130 ° (vertical) typ, 140° (horizontal) typ
Luminance output 300 cd/m ²(typ)
Contrast ratio 700:1 (typ)
Faceplate coating Anti-glare with hard-coating 3H
Backlight 4 CCFLs backlight
Response Time 8 ms typical (Black to White)
Resolution
Horizontal scan range 30 kHz to 81 kHz (automatic)
Vertical scan range 56 Hz to 76 Hz
Optimal preset resolution 1280 x 1024 at 60 Hz
Highest preset resolution 1280 x 1024 at 75 Hz
Preset Display Modes
The following table lists the preset modes for which Dell guarantees image size and centering:
Display Mode Horizontal Frequency
(kHz)
Vertical Frequency (Hz) Pixel Clock (MHz) Sync Polarity (Horizontal/Vertical)
VGA, 720 x 400 31.5 70.1 28.3 -/+
VGA, 640 x 480 31.5 60.0 25.2 -/-
VESA, 640 x 480 37.5 75.0 31.5 -/-
VESA, 800 x 600 37.9 60.3 40.0 +/+
VESA, 800 x 600 46.9 75.0 49.5 +/+
VESA, 1024 x 768 48.4 60.0 65.0 -/-
VESA, 1024 x 768 60.0 75.0 78.8 +/+
VESA, 1152 x 864 67.5 75.0 108.0 +/+
VESA, 1280 x 1024 64.0 60.0 108.0 +/+
VESA, 1280 x 1024 80.0 75.0 135.0 +/+
Electrical
Video input signals Analog RGB: 0.7 Volts +/-5%, 75 ohm input impedance
Synchronization input signals separate horizontal and vertical,
3.3V Cmos or 5V TTL level, positive or negative sync.
AC input voltage / frequency / current 100 to 240 VAC / 50 or 60 Hz + 3 Hz / 1.0 A (Max.)
Inrush current 120V: 40A (Max.)
240V: 80A (Max.)
Physical Characteristics
Signal cable type D-sub: Detachable, Analog, 15pin, blue connector, attached to the monitor