Curtis LCD3227A-2 - Manual (Page 6)

1. Open the battery door.
BATTERY REPLACEMENT
When the batteries become weak, the operating distance of the remote control is greatly
reduced and you will need to replace the batteries
CAUTION : Danger of explosion if battery is incorrectly replaced.
NOTES:
If the remote control is not going to be used for a long time, remove the batteries to avoid
damage caused by battery leakage corrosion
Do not mix old and new batteries. Do not mix ALKALINE, standard (CARBON-ZINC) or
rechargeable (NICKEL-CADMIUM) batteries
Always remove batteries as soon as they become weak
Weak batteries can leak and severely damage the remote control
WARNING:
Do not dispose batteries in a fire. Batteries may explode or leak
Batteries shall not be exposed to excessive heat such as sunshine, fire or the like
2. Insert 2 "AAA" batteries.
USING THE REMOTE CONTROL
Point the remote control at the remote sensor located on the unit.
When there is a strong ambient light source, the performance of the infrared remote sensor.
ay be degraded, causing unreliable operation.
The recommended effective distance for remote operation is about 16 feet (5 meters).
M
Getting Started
5
Accessories
Please check and identif y the supplied accessories.
Remote control ................................................................................................................ x 1
Battery AAA ................................................................................................................ x 2
Warranty Card ................................................................................................................. x 1
Instruction Manual ........................................................................................................... x 1
Power Cord .................................................................................................................... x 1
( )
TO INSTALL THE BATTERIES