Dell Alienware M14x (Early 2011) - Manual (Page 30)

Replacing the Status-Light Board
1. Follow the instructions in Before You Begin .
2. Align the slot on the status-light board with the alignment post on the palm rest assembly.
3. Replace the screw that secures the status-light board to the palm-rest assembly.
4. Route the status-light board cable through the routing guides on the palm- rest assembly.
5. Replace the palm-rest assembly (see Replacing the Palm-Rest Assembly ).
6. Replace the keyboard (see Replacing the Keyboard ).
7. Replace the center-control cover (see Replacing the Center-Control Cover ).
8. Replace the battery pack (see Replacing the Battery Pack ).
9. Replace the base cover (see Replacing the Base Cover ).
Back to Contents Page
1 status-light board 2 screw
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.