Dell 7609WU Projector - Manual (Page 28)

Using Your Projector 28
1 Power Turns the projector on and off. For more
information, see "Turning Your Projector On" on
page 21 and "Turning Your Projector Off" on
page 21.
Press and hold for 10 seconds to exit the lockup
state and go back to standby mode when
projector is in lockup state. (eg. Lamp error, over
heat etc.)
2 Enter Press to confirm the selection.
3 Right Press to adjust the OSD setting.
4 Down Press to select OSD items.
5 Aspect Ratio Press to change the aspect ratio of a displayed
image.
6 Page up Press to move to the previous page.
7 Mute Press to mute or un-mute the projector speaker.
8 Page down Press to move to the next page.
9 Video mode The Dell 7609WU projector has preset
configurations that are optimized for displaying
data (PC Graphics) or videos (movies, games,
etc.). Press the Video Mode button to toggle
between Presentation mode, Bright mode,
Movie mode, sRGB, or CUSTOM mode (for the
user to set up and save preferred settings).
Pressing the Video Mode button once will show
the current display mode. Pressing the Video
Mode button again will allow the projector to
switch between display modes.
10 Blank screen Press to hide / un-hide the image.
11 Up Press to select OSD items.
12 Left Press to adjust the OSD setting.
13 Menu Press to activate the OSD.
14 Volume up Press to increase the volume.
15 Laser Aim the remote control at the screen, press and
hold the laser button to activate the laser light.
16 Volume down Press to decrease the volume.