Dell PowerEdge Rack Enclosure 4620S - Manual (Page 8)

Cable Routing Procedures for Dell™ PowerEdge™ T710 Systems
Page 6
Section 3: Replacing a Power Supply on a PowerEdge™ T710 System With a
CMA
1. Remove the CMA tray.
2. Swing the CMA to its service position.
3. Disengage the strain relief and disconnect the power cord from the power supply.
4. Remove and replace the power supply as shown in Figure 7.
5. Plug in the power cord, re-engage the strain relief, return the CMA to the closed (retracted)
position, and reinstall the CMA tray.
Figure 7: Replacing the Power Supply