Dell Dimension 1100/B110 - Manual (Page 61)

Removing and Installing Parts
61
3 Remove the securing screw from the card bracket.
4 Grasp the card by its top corners, and ease it out of its connector.
5 If you are removing the card permanently, install a filler bracket in the empty card-slot opening.
If you need a filler bracket, contact Dell (see page 94).
NOTE:
Installing filler brackets over empty card-slot openings is necessary to maintain FCC certification of the
computer. The brackets also keep dust and dirt out of your computer.
NOTICE:
To connect a network cable, first plug the cable into the network wall jack and then plug it into the
computer.
6 Close the computer cover, reconnect the computer and devices to electrical outlets, and then turn
them on.
7 Remove the card’s driver from the operating system.
8 If you removed a sound card:
a Enter system setup (see page 82), select Audio Controller, and then change the setting to On.
b Connect external audio devices to the audio connectors on the computer back panel.
9 If you removed an add-in network connector:
a Enter system setup (see page 82), select Network Controller, and then change the setting to On.
b Connect the network cable to the integrated connector on the computer back panel.
Front Panel
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
CAUTION:
To guard against electrical shock, always unplug your computer from the electrical outlet before
opening the cover.