Dell Dimension 1100/B110 - Manual (Page 16)

16
Setting Up and Using Your Computer
Adjusting the Picture
If an error message notifies you that the current resolution and color depth are using too much memory and
preventing DVD playback, adjust the display properties:
1 Click the Start button and click Control Panel.
2 Under Pick a category, click Appearance and Themes.
3 Under Pick a task..., click Change the screen resolution.
4 In the Display Properties window, click and drag the bar in Screen resolution to change the setting to
800 by 600 pixels.
5 Click the drop-down menu under Color quality, and then click Medium (16 bit).
6 Click OK.
Copying CDs and DVDs
NOTE:
Please observe all copyright laws when creating CDs or DVDs.
This section applies only to computers that have a CD-RW, DVD+/-RW, or CD-RW/DVD (combo)
drive.
NOTE:
The types of CD or DVD drives offered by Dell may vary by country.
The following instructions explain how to make an exact copy of a CD or DVD. You can also use Sonic
DigitalMedia for other purposes, such as creating music CDs from audio files stored on your computer or
backing up important data. For help, open Sonic DigitalMedia and then click the question mark icon in
the upper-right corner of the window.
How to Copy a CD or DVD
NOTE:
CD-RW/DVD combo drives cannot write to DVD media. If you have a CD-RW/DVD combo drive and you
experience recording problems, check for available software patches on the Sonic support website at
www.sonic.com.
The DVD-writable drives installed in Dell
™
computers can write to and read DVD+/-R, DVD+/-RW
and DVD+R DL (dual layer) media, but cannot write to and may not read DVD-RAM or DVD-R DL
media.
NOTE:
Most commercial DVDs have copyright protection and cannot be copied using Sonic DigitalMedia.
1 Click the Start button, point to All Programs→ Sonic→ DigitalMedia Projects and then click Copy.
2 Under the Copy tab click Disc Copy.
3 To copy the CD or DVD:
• If you have one CD or DVD drive, ensure that the settings are correct and click the Disc Copy
button. The computer will read your source CD or DVD and copy the data to a temporary folder
on your computer hard drive.
When prompted, insert a blank CD or DVD into the drive and click OK.