Dell XPS One 24 (Late 2008) - Manual (Page 49)

System Setup 49
Clearing CMOS Settings
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions that shipped with your computer.
CAUTION: The computer must be disconnected from electrical outlet to clear the
CMOS setting.
1 Follow the procedure in "Before You Begin" on page 9.
2 Remove the computer cover (see "Replacing the Computer Cover" on
page 11).
3 Locate the 2-pin CMOS jumper on the system board.
4 Move the 2-pin jumper plug from pins 3 and 2 to pins 1 and 2.
5 Wait for five seconds for the CMOS to clear.
6 Move the 2-pin jumper plug back to pins 3 and 2.
NOTE: The computer will not turn on if you do not replace the 2-pin jumper on
pins 3 and 2.
7 Replace the computer cover (see "Replacing the Computer Cover" on
page 11).
8 Turn on the computer.
9 The message
CMOS settings wrong
appears on the screen. Restart
the computer.
The message
CMOS checksum error. Press F1 to run
setup. Press F2 to load default values and
continue
appears on the screen.
10 Press to load default values and continue.
A5_bk0.book Page 49 Tuesday, February 5, 2013 11:19 AM