Routing the cables, Figure 5: left-side mounted cma installation, Figure 6: cable routing without a cma – Dell PowerEdge Rack Enclosure 4820 User Manual
Page 7
Cable Routing Procedures for Dell™ PowerEdge™ T610 Systems
Page 5
Figure 5: Left-Side Mounted CMA Installation
Section 2: Cabling a Dell™ PowerEdge™ T610 System Without a CMA
NOTE: The CMA on Dell™ PowerEdge™ T610 systems is optional. Without the CMA installed, the
system must be powered down and all cables disconnected before it can be removed from the rack.
2.1
Routing the Cables
1. Connect all applicable cables to the rear of the system and verify that all connections are secure.
2. Using the hook and loop straps supplied with the rail kit, bundle the cables and secure them to
either the left or right CMA attachment brackets as described in the
Rack Installation Instructions
.
See Figure 6 for an example of data cables secured to the left CMA bracket and power cables
secured to the right CMA bracket.
3.
It is recommended that the cables be secured to the outer brackets, but cables may be secured to
the inner brackets as well if desired.
Figure 6: Cable Routing Without a CMA