Cards, Pci cards – Dell Dimension 5000 User Manual
Page 16
6.
Replace the
computer cover
.
7.
Connect your computer and devices to electrical outlets, and turn them on.
8.
Right-click the My Computer icon and click Properties.
9.
Click the General tab.
10.
To verify that the memory is installed correctly, check the amount of memory (RAM) listed.
Removing Memory
1.
Follow the procedures in "
Before you Begin
."
2.
Press out the securing clip at each end of the memory module connector.
3.
Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back and forth to remove it from the connector.
Cards
Your Dell™ computer provides the following slots for PCI and PCI Express cards:
l
Two PCI card slots
l
One PCI Express x16 card slot
l
One PCI Express x1 card slot
PCI Cards
Your computer supports two PCI cards.
If you are replacing a card, remove the current driver for the card from the operating system.
NOTICE:
To connect a network cable, first plug the cable into the network device and then plug the cable into the computer.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
NOTICE:
To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your
computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.