Dell Inspiron 8000 - Manual (Page 47)

Network Problems
Windows® Error Messages
General Program Problems
A program crashes
A program stops responding
A solid blue screen appears
Check the network cable connector— Ensure that the network cable connector is firmly connected to the connector
on the computer and the network wall jack.
Check the network lights on the network connector— Green indicates that the network connection is active. If the
status light is not green, try replacing the network cable. Amber indicates that the network card driver is loaded and
the card is detecting activity.
Restart the computer— Try to log on to the network again.
Contact your network administrator— Verify that your network settings are correct and that the network is
functioning.
x:\ is not accessible. The device is not ready— Insert a disk into the drive and try again.
A filename cannot contain any of the following characters: \ / : * ? " < > |— Do not use these characters in
filenames.
Not enough memory or resources. Close some programs and try again— You have too many programs open. Close
all windows and open the program that you want to use.
The file being copied is too large for the destination drive— The file that you are trying to copy is too large to fit on
the disk, or the disk is too full. Try copying the file to a different disk or use a larger capacity disk.
A required .DLL file was not found— The program that you are trying to open is missing an essential file. To remove
and then reinstall the program:
Windows Me:
1. Click the Start button, point to Settings, and then click Control Panel.
2. Double-click the Add/Remove Programs icon.
3. Select the program that you want to remove.
4. Click Add/Remove and follow the prompts on the screen.
5. See the program documentation for installation instructions.
Windows 2000:
1. Click the Start button, point to Settings, and then click Control Panel.
2. Double-click the Add/Remove Programs icon.
3. Select the program that you want to remove.
4. Click Change/Remove and follow the prompts on the screen.
5. See the program documentation for installation instructions.
See the software documentation— Many software manufacturers maintain websites with information that may help
you to solve the problem.
Press — In the Close Program window, select the program that is no longer responding. Then
click End Task.
Turn the computer off— If the computer does not respond to a keystroke or a proper shutdown, press the power
button until the computer turns off. Press the power button again to restart the computer. The solid blue screen
appears because you were not able to perform a proper Windows shutdown. ScanDisk will automatically run during
the start-up process. Follow the instructions on the screen.