Dell Studio 1536 (Mid 2008) - Manual (Page 18)

7. Replace the keyboard (see Replacing the Keyboard ).
8. Replace the center control cover (see Replacing the Center Control Cover ).
9. Close the display and turn the computer over.
10. Replace and tighten the two screws securing the display assembly to the bottom of the computer.
11. Replace the Mini-Card and connect the antenna cables to it (see Replacing the Mini-Card ).
12. Replace the base cover (see Replacing the Base Cover ).
Display Bezel
Removing the Display Bezel
1. Follow the instructions in Before You Begin .
2. Remove the display assembly (see Removing the Display Assembly ).
3. Gently push the display bezel outwards on each of the four sides to release the bezel from the display panel.
Replacing the Display Bezel
1. Follow the instructions in Before You Begin .
2. Starting at any corner, use your fingers to gently snap the bezel into place to secure it to the display panel.
3. Replace the display assembly (see Replacing the Display Assembly ).
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.
CAUTION: The following instructions are not applicable to Edge-to-Edge display panels, which should not be disassembled.
NOTICE: Removal of the bezel from the display bottom cover requires extreme care to avoid damage to the bezel and the display panel.
1 display bezel
NOTE: In some computers, the display bezel might have double-sided tape on both ends. To reuse the tape, carefully remove the bezel.
CAUTION: Before you begin the following procedure, follow the safety instructions that shipped with your computer.