Dell M209X Projector - Manual (Page 25)

Using Your Projector 25
DISPLAY (in Video Mode)
V
IDEO
M
ODE
—Select a
mode to optimize the
display on how the
projector is being used:
PC, Movie, sRGB
(provides more accurate
color representation),
Game, and Custom (set
your preferred settings). If
you adjust the settings for
White Intensity or
Degamma, the projector
automatically switches to Custom.
S
IGNAL
T
YPE
—Manually select signal type RGB, YCbCr, or YPbPr.
Z
OOM
—Press to digitally magnify a default area of image in the center of the
screen and press to reduce the zoomed image.
Z
OOM
N
AVIGATION
—Press to navigate projection screen.
W
HITE
I
NTENSITY
—Set 0 to maximize the color reproduction and 10 to maximize
the brightness.
D
EGAMMA
—Adjust among the 4 preset values to change the color performance of
the display.
LAMP
L
AMP
H
OUR
—Displays the
operating hours since the last
lamp timer reset.
P
OWER
S
AVING
—Select Yes to
set the Power Saving delay
period. The delay period is
the time you want the
projector to wait without an
input signal. By default, the
delay period is set to 120
minutes. However, you can set this to 5 minutes, 15 minutes, 30 minutes, 45
minutes, 60 minutes, or 120 minutes.
If an input signal is not detected during the delay period, the projector turns off
the lamp and goes into power saving mode. If an input signal is detected within
the delay period, the projector automatically turns on. If an input signal is not