Display, Display assembly, Removing the display assembly – Dell Inspiron 11z (1120, Mid 2010) User Manual
Page 20
Back to Contents Page
Display
Dell™ Inspiron™ 1121 Service Manual
Display Assembly
Removing the Display Assembly
1.
Follow the instructions in
Before You Begin
.
2.
Remove the battery (see
Removing the Battery
).
3.
Remove the keyboard (see
Removing the Keyboard
).
4.
Follow the instructions from
step 4
to
step 6
in
Removing the Hard Drive
.
5.
Remove the palm rest (see
Removing the Palm Rest
).
6.
Disconnect the Mini-Card antenna cables from the Mini-Card(s).
7.
Make note of the cable routing and carefully dislodge the Mini-Card antenna cables from the routing guides.
8.
Disconnect the display cable from the system board connector.
9.
Remove the two screws (one on each side) that secure the display assembly to the computer base.
10.
Lift and remove the display assembly off the computer base.
WARNING:
Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION:
Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™
is not covered by your warranty.
CAUTION:
To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION:
To help prevent damage to the system board, remove the main battery (see
Removing the Battery
) before working inside the
computer.
1
display cable connector
2
Mini-Card antenna cables