Dell Inspiron Mini 12 (1210, Late 2008) - Manual (Page 27)

2. Remove the palm rest. See Replacing the Palm Rest .
3. Disconnect the antenna cables from the Mini-Card.
4. Release the Mini-Card by removing the securing screws.
5. Lift the Mini-Card out of its system board connector.
6. To replace the Mini-Card, remove the new Mini-Card from its packing.
7. Insert the Mini-Card at a 45-degree angle into the appropriate system board connector. For example, the WLAN card connector is labeled WLAN and so
on.
8. Press the other end of the WLAN card down into the slot on the system board and replace the two securing screws.
9. Connect the appropriate antenna cables to the Mini-Card you are installing. The following table provides the antenna cable color scheme for each Mini-
Card supported by your computer.
1 Mini-Card 2 securing screw (2)
3 antenna cable connector (2)
NOTICE: When the Mini-Card is not in the computer, store it in protective antistatic packaging. See the information on protection against electrostatic
discharge in the safety information that shipped with your computer.
NOTICE: The connectors are keyed to ensure correct insertion. If you feel resistance, check the connectors on the card and on the system board, and
realign the card.
NOTICE: To avoid damage to the Mini-Card, never place cables under the card.
NOTICE: Use firm and even pressure to slide the card into place. If you use excessive force, you may damage the connector.
Connectors on the Mini-Card Antenna Cable Color Scheme