A b c d – Dell Precision 650 User Manual
Page 38
38
S e t u p a n d Q u i c k Re f e r e n c e G u i d e
www
.dell.com | support.dell.com
A possible microprocessor
failure has occurred.
Reinstall the microprocessor and restart the computer.
Memory modules are
detected, but a memory
failure has occurred.
1
Reset the memory modules to ensure that your
computer is successfully communicating with the
memory.
2
Restart the computer.
3
If the problem still exists, remove all the memory
modules and install one memory module in
memory module connector 4.
4
Restart the computer.
The following message appears:
Alert!
Operating in Debug Mode. Please
Populate Memory in Pairs for Normal
Operation
.
5
Press
6
Run the System Memory test group in the Dell
Diagnostics.
7
If the memory module passes, shut down the
computer, remove the memory module, and repeat
the process with the remaining memory modules
until a memory error occurs during start-up or
diagnostic testing.
If the first memory module tested is defective,
repeat the process with the remaining modules to
ensure that the remaining modules are not
defective.
8
When the defective memory module is identified,
contact Dell for a replacement.
NOTE: If necessary, the computer can operate in
debug mode until new memory modules are installed.
Light Pattern
Problem Description
Suggestion Resolution
= y e l l o w
= g r e e n
= o f f
A B C D
A B C D