Connect Tech CTIM-00054 - Manual (Page 9)

PCI/104-Express to PCI Express Adapter
9 www.connecttech.com CTIM-00054 (0.01) 3/26/2010
800-426-8979 | 519-836-1291
5. Power Notes
Some PCI/104-Express SBC systems will not come with +3.3V power over the PCI/104-Express connector.
If this is the case, enable jumper block J1 Position A** (See errata) to enable the on board regulator to
generate +3.3V (which is limited to 1.5A) for your PCI Express card. If the SBC you are using does provide
+3.3V power, do not enable this jumper.
PCI/104-Express Power Specifications
Please refer to your PCI/104-Express SBC manual for actual ratings used.
6. Product Errata
ADG020 Limitations
This product provides a single x1 lane PCI Express connection. PCI Express x4, x8 or x16 lane cards
cannot be used. Please use the ADG017 board for this functionality.
This product only provides +3.3V power to the PCI Express connector it does not provide any +12V.
Please ensure your x1 PCI Express board does not use +12V. Please use the ADG017 for full +12V
operation.
Silkscreen Corrections **
The silkscreen label for Jumper block J1 is incorrect on all Rev. A PCBs.
It should read:
Position A - ON: Use +3.3V regulator
OFF: Use +3.3V from PCI/104-Express
Position B - ON: Select x4, x8 or x16 Lane Link
OFF: Select x1 Lane Link