5 self-printing function – Citizen Systems Compact desk-top dot matrix printer CBM-910 Type II User Manual
Page 22
— 18 —
31
32
33
34
35
36
37
38
12345678
39
3A
3B
3C
3D
3E
3F
40
9*+,-./@
41
42
43
44
45
46
47
48
ABCDEFGH
49
4A
4B
4C
4D
4E
4F
50
IJKLMNOP
51
52
53
54
55
56
57
58
QRSTUVWX
4.5 Self-Printing Function
When activating self-printing function, be sure to start with a paper loaded (or in the
printable state).
(1)
Test printing
Turn the printer power on while pressing and holding the LF switch, and the
printer starts printing the status of current setting of DIP switch (including the
content of setting in case of serial printer) and all characters available with the
printer.
The SEL lamp is held off and BUSY signal is output during test printing.
On completion of test printing, the printer enters the standby state awaiting print
data.
(2)
Hexadecimal dump mode
Turn the printer power on with the LF switch and SEL switch pressed and held.
The printer prints Hexadecimal Dump characters and then prints all data sent
from the host in hexadecimal code.
When data for the last line is not sufficient for full one line, data of the last line is
printed out with SEL switch pressed and deselected (OFF LINE).
This mode lasts till power is turned off.
Example of Printing in Dump Mode