Coleman 5600 User Manual
Page 28
Ц
Ц
Assemble the Motor Mount
Bracket to the right outside of
the Firebox.
Ц
Ц
Assemble the Rotisserie to
the Firebox.
Step
25
Hardware shown actual size
(TN)
M6 x 15mm Screw
(2) Qty.
(UO)
M6 Locking Hex Nut
(2) Qty.
25-A
TN (x2)
UO (x2)
Motor Mount Bracket
25-C
Handle
Set Collar
Fork
Slip Collar
Fork
Spit Rod
NOTE:
Machined
Groove
Toward
Handle
25-D. Insert Pointed Tip of the Spit Rod into the Motor.
Ц
Ц
Place Slip Collar on Firebox Wall. Make sure
the pointed tip of the Spit Rod stays in the
Motor.
Ц
Ц
Push Set Collar against the Slip Collar, provide
a small gap to allow the Spit Rod to freely turn.
Ц
Ц
Tighten the thumbscrews on the Set Collar
and the Forks to hold in place.
25-A. Attach the Motor Mount Bracket to the metal side panel
using two Screws (TN) and two Hex Nuts (UO).
25-B. Slide the Motor onto the Motor Mount Bracket.
25-C. Loosely assemble the Rotisserie parts as shown in
Figure 25-C. Do not tighten the thumbscrews until prop-
erly positioned in step 25-D.
25-B
Motor
25-D
Set Collar
Slip Collar
Firebox
Wall
Pointed Tip
28
Small Gap here