Craftsman 137.21194 - Manual (Page 31)

30 31 30 31
WARNING
!
SLIDE CUTTING WIDE BOARDS UP
TO 8 in. WIDE (FIG. AA)
To avoid injury:
● Never pull the cutting head
assembly and spinning blade
toward you during the cut. The
blade may try to climb up on the
top of the workpiece, causing the
cutting assembly and spinning
blade to kick back forcefully. The
cutting head assembly should
be drawn back completely then
pushed forward when sawing.
● Let the blade reach full speed
before cutting. This will help
reduce the risk of a thrown
workpiece.
COMPOUND CUT (FIG. Z)
A compound cut is the combination of a
miter and a bevel cut simultaneously.
1. Loosen the bevel lock handle (1)
and position the cutting head at the
desired bevel position. Lock the
bevel lock handle.
2. Loosen the miter handle (2). Lift up
the positive stop locking lever and
position the table at the desired
angle. Release the positive stop
locking lever and lock the miter
handle.
BEVEL CUT (FIG. Y)
1. When a bevel cut is required,
loosen the bevel lock handle (1) by
turning it clockwise.
2. Tilt the cutting head to the desired
angle, as shown on the bevel scale
(2).
3. The blade can be positioned at
any angle, from a 90° straight cut (
0° on the scale) to a 45° left bevel.
Tighten the bevel lock handle (1)
to lock the cutting head in position.
Positive stops are provided at 0°
and 45°.
Fig. Y
Fig. Z
2
1
2
1