Craftsman 137.21194 - Manual (Page 22)

22 23 22 23
saw must be connected to the power
source and the laser on/off switch must
be turned on for the laser line to show.
AVOID DIRECT EYE CONTACT
● Laser is radiated when laser
guide is turned on. Avoid direct
eye contact. Always un-plug the
miter saw from power source
before making any adjustments.
● Laser Warning Label: max
output <1mW DIODE LASER:
630-670nm, Complies with
21CFR 1040.10 and 1040. 11.
Class II laser product.
● NOTE: All the adjustments for the
operation of this machine have
been completed at the factory. Due
to normal wear and use, some
occasional readjustments may be
necessary.
● CAUTION-Use of controls or
adjustments or performance of
procedures other than those
specified herein may result in
hazardous radiation exposure.
● CAUTION-The use of optical
instruments with this product
will increase eye hazard.
● Do not attempt to repair or
disassemble the laser. If
unqualified persons attempt
to repair this laser product,
serious injury may result. Any
repair required on this laser
product should be performed
by authorized service center
personnel.
● To avoid injury, never use the saw
without the cover plate secure
in place. It keeps the arbor bolt
from falling out if it accidentally
loosens, and helps prevent the
spinning blade from coming off
the saw.
● Make sure the collars are clean
and properly arranged. Lower
the blade into the table and
check for any contact with the
metal base or the turn table.
THE LASER GUIDE (FIG. N)
1. To turn laser on, press on/off rocker
switch (1) to “ON” position.
2. To turn off laser, press on/off rocker
switch to “OFF” position.
Fig. N
THE LASER BEAM
For your own safety, never connect
the plug to power source outlet
until all the adjustment steps
are complete and you have read
and understood the safety and
operational instructions.
Your tool is equipped with the Laser
Trac ® cutting guide using Class II laser
beam. The laser beam will enable you
to preview the saw blade path on the
stock to be cut before starting the miter
saw. This laser guide is powered by the
transformed alternating current supply
directly through the power lead. The
WARNING
!
WARNING
!
1
WARNING
!