Tools needed for assembly – Craftsman 137.21194 User Manual
Page 12
12
13
12
13
COMBINATION SQUARE MUST BE TRUE
Should not gap or overlap when square is flipped over (see dotted figure).
Should not gap or overlap when square
flipped over (see dotted figure).
Draw light line on
board along this edge.
Straight edge or a 3/4 in. board, this
edge must be perfectly straight.
Phillips Screwdriver
Blade Wrench
Adjustable Wrench
6mm Hex Wrench
Combination Square
Supplied
Not supplied
Slotted Screwdriver
TOOLS NEEDED FOR ASSEMBLY
See also other documents in the category Craftsman Power saws:
- TS3650 (8 pages)
- 113.24181 (40 pages)
- 572.24700 (6 pages)
- 118.22000 (15 pages)
- 137.21807 (56 pages)
- 113.244513 (20 pages)
- 315.24234 (42 pages)
- 509347 (48 pages)
- 351.21833 (12 pages)
- 113.298761 (56 pages)
- 137.248830 (31 pages)
- 113.2472T0 (40 pages)
- 286.17589 (48 pages)
- 137.218030 (30 pages)
- 137.21602 (36 pages)
- 509399 (52 pages)
- 137.21236 (29 pages)
- 137.21239 (50 pages)
- CONTRACTOR 351.21833 (36 pages)
- 286.25574 (48 pages)
- 286.26829 (46 pages)
- 315.220381 (82 pages)
- 113.248510 (52 pages)
- 315.235380 (38 pages)
- 315.228110 (54 pages)
- 315.212220 (39 pages)
- 137.212290 (28 pages)
- 917.27103 (60 pages)
- 315.216360 (26 pages)
- 172.267700 (18 pages)
- 315.108330 (20 pages)
- 315.108990 (20 pages)
- 315.212080 (36 pages)
- 315.212100 (38 pages)
- 315.212100 (4 pages)
- 315.212110 (38 pages)
- 315.212120 (36 pages)
- 315.212130 (36 pages)
- 315.214490 (32 pages)
- 315.214500 (34 pages)
- 315.214770 (32 pages)
- 315.228310 (64 pages)
- 315.228390 (66 pages)
- 315.228410 (8 pages)