Chicago Electric MIG 180 Wire Feed Welder 68886 User Manual

Page 11

Page 11

For technical questions, please call 1-800-444-3353.

SKU 68886

7. Turn the Feed Tensioner knob counterclockwise to

loosen it enough to pull it down to remove tension.

(Do not loosen the Tensioner knob too much, or the

Tensioner will come apart.)

Then, swing the Feed Swing Arm up.

Feed Roller Instructions:

Check that the Feed Roller is turned to properly

match the wire size marked on the Wire Spool:

A. Twist the Feed Roller Knob about 1/3 of a

turn counterclockwise  until it stops.

B. Pull the Feed Roller Knob straight

off to expose the Feed Roller.

C. Flip the Feed Roller as needed and

confirm that the number facing you is the

same as the wire diameter on the Spool.

(0.8mm = .030" & 0.6mm = .023")

D. Place the Feed Roller Knob back into place in

the same orientation it was removed in, and twist

it about 1/3 of a turn clockwise to secure it.

Feed Swing

Arm

Feed

Tensioner

Feed

Roller

Knob

Feed

Roller

.030/.035 groove

and stamp

.023 groove

and stamp

SAFETY

MAINTENANCE

BASIC WELDING

WELDING TIPS

SETUP