ClearSounds AMPLIFIED FREEDOM PHONE CSC600D - Manual (Page 40)

40 – ENGLISH
No Strobe ringer and/or bed shaker will not activate
1. Make sure the strobe and/shaker switch is turned ON
(page 18).
2. Make sure the bed shaker is plugged into the correct jack.
3. Make sure the bed shaker is plugged in all the way.
No amplification
1. Check to see if Volume has been turned up (pages 15-16)
2. The AC adapter is required; make sure the AC adapter is
plugged into the wall and into appropriate jack on the
phone.
Low handset or speaker volume
1. Check the receiver or speaker volume settings
(pages 15-16 or 19-20)
Can’t be heard by other party
1. Check that all phone cord connections are securely plugged
into the phone and wall jack.
Noise, Static, Interference while using the phone
1. A filter may be required for your home when you have DSL
service or live near radio towers.
2. Make sure the AC adapter is not plugged into the wall outlet
with other appliances.
3. Try relocating the phone to another location.
No numbers dialed when memory button is pressed
1. No number stored in that memory button (page 24).
2. Make sure phone number was programmed and saved
(page 24).
3. Make sure programming is done in the correct dialing mode
(touch-tone or pulse).
Caller ID information does not show
1. Make sure you are subscribed to Caller ID service through
your local phone company.
2. Let the phone ring a couple of times as there may be a
delay in receiving the Caller ID information.
No Caller ID information while on a call
1. Make sure you service provides Caller ID information while
you are on a call. This is sometimes known as “Caller ID on
Call Waiting” or “Type II Caller ID”.
2. The phone cannot display the information if another phone
on the same line is in use.