Compaq iP-40 - Manual (Page 35)

E-
Displaying the Pointer
This operation displays the pointer in the currently projected image.
Deleting the Projection Image and Audio
This operation deletes the currently projected image and audio without switching off the lamp.
Operation with the Projector
The ability to delete the projection image is not available from
the operation panel of the projector.
Operation with the Remote Control
Press the MUTE button.
Operation with the Projector
The ability to turn on and turn off the pointer is not
available from the operation panel of the projector.
Operation with the Remote Control
Press the SET/POINTER button.
One more press of the SET/POINTER button while the
pointer is displayed will turn off the pointer display.
Moving the Pointer
Operation with the Projector
Scrolling is not possible from the main unit’s control panel.
Operation with the Remote Control
Press the SCROLL (
▲▼◀▶) buttons.
See Page E-35 for information about the form, color, and size of the pointer.
NOTE:
If the brightness is adjusted while the pointer is displayed, the pointer disappears temporarily, but it reappears once the
brightness adjustment bar turns off.
During Keystone compensation (trapezoidal compensation), when the pointer is displayed, the pointer color may become
striped. It is not a failure.
For instructions on setting the mute screen, see page E-35.
Regular Operation
NOTE: When a fixed period of time elapses (about 30 minutes) with the video/audio muted, a message will be displayed to
check whether to shut down the projector. Selection of "Yes" will set the projector to the standby mode, while a selection of "No"
will again delete the video/audio.
When there has been an absence of an operation for 15 seconds during the display of the above confirmation message, the pro-
jector automatically enters the standby mode.