FRIGIDAIRE FFEC3624PW - Manual (Page 10)

10
SETTING SURFACE CONTROLS
Operating the Warm Zone Feature
(Some Ceramic Glass Cooktop models only)
To operate the warm zone
Your appliance is equipped with a warm zone. The
purpose of the warm zone is to keep hot cooked foods at
serving temperature. Always start with hot food. It is not
recommended to heat cold food on the warm zone.
Use the warm zone to keep cooked foods hot such
as: vegetables, gravies, casseroles, soups, stews,
breads, pastries and oven-safe dinner plate.
All food placed on the warm zone should be covered
with lid or aluminum foil to maintain quality. For best
results, when warming pastries or breads, the cover
should have an opening to allow moisture to escape. Do
not use plastic warp to cover food. Plastic may melt onto
the surface and be very diffi cult to clean.
Use only dishware, utensils and cookware recommended
for oven and cooktop use on the warm zone.
CAUTION
Unlike the surface elements, the warm zone will not
glow red when it is hot. Always use potholders or oven
mitts when removing food from the warm zone as
cookware and plates will not be hot
Indicator lights
The hot surface indicator light, located under the cooktop,
will come on when the control is set and will continue to
glow until the glass cooktop has cooled down to moderate
level.
To Set the Warm Zone Control
1. To set the control, turn the knob to the ON position.
2. When done, turn the control to OFF. The warm zone
will remain warm until the hot surface indicator light
goes off.
ON
Figure 1 -Control knob shown is typical only.