FRIGIDAIRE FPHG2399PF - Manual (Page 22)

22
CHANGING THE FILTER
Locating the Filters
Your refrigerator is equipped with water filtering system.
The water filter system filters all dispensed drinking
water, as well as the water used to produce ice.
Water Filter
The water filter is located at the top right side of the
fresh food compartment.
Ordering Replacement Filters
To order your replacement filters, please visit our online
store at www.frigidaire.com/store, by calling toll-free
at 877-808-4195, or by visiting the dealer where you
purchased your refrigerator. Frigidaire recommends
that you order extra filters when you first install your
refrigerator, and that you replace your filters at least once
every six months.
Here is the product number to request when ordering:
PureSource Ultra
TM Water Filter
Part #ULTRAWF
Replacing the Water Filter
In general, you should change the water filter every six
months to ensure the highest possible water quality. The
Water Filter Status light on the user interface prompts
you to replace the filter after a standard amount of water
(200 gallons/757 liters for PureSource Ultra TM ) has
flowed through the system. The water filter status light
on this model is not performance tested or certified
by NSF.
If your refrigerator has not been used for a period of time
(during moving for example), change the filter before
reinstalling the refrigerator.
Filter Cartridge
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Test & certification results:
• Rated Capacity - 200 gallons/757 liters for
PureSource Ultra TM ice and water filter
• Rated service flow - .50 gallons per minute
• Operating Temp.: Min. 33°F, Max. 100°F
• Maximum Rated Pressure - 100 pounds per
square inch
• Recommended Minimum Operating Pressure: 30
pounds per square inch
To replace your PureSource Ultra
TM
water filter:
It is not necessary to turn the water supply off to change
the filter. Be ready to wipe up any small amounts of water
released during the filter replacement.
1 Turn
Off the ice maker by raising the wire signal arm.
2 Remove the filter by pushing on the end/face of
the filter.
3 Slide the old water filter cartridge straight out of the
housing and discard it.
4 Unpackage the new filter cartridge. Using the
alignment guide, slide it gently into the filter housing
until it stops against the snap-in connector at the
back of the housing.
5 Push firmly until the cartridge snaps into
place (you should hear a click as the cartridge
engages the snap-in connector).
6 Turn On the ice maker by lowering the wire signal arm.
7 Press and hold the Water Filter button on the
Ice & Water Dispenser control panel for three
seconds. When the display changes from Red to
Green, the status has been reset.
8 After replacing the water filter and in order for the ice
maker to work properly, it is necessary to clear air from
water filter tubing. Once ice maker begins making ice,
allow the bucket to fill completely, then discard the
first TWO FULL buckets of ice. It will take at least two
days to completely fill the bucket on regular ice making
mode or 1½ days on fast ice mode.
The PureSource Ultra TM ice and water filter
system is tested and certified to NSF/ANSI
Standards 42 and 53 for the reduction of claims
specified on the performance data sheet.
More about your Advanced Water Filter