Baumer PA200 - Manual (Page 19)

PA200
www.baumer.com 19
4.3 Programming lock
Programming access depends on the selected input configuration.
1. Voltage 20 or 200 V: Press and hold for 5.
Enter 0 or 1 in line„LC“.
2. All other input configurations provide access rights at the end of
display configuration as follows:
After parameterization of „dSP2“ press and hold for 5 s.
Enter 0 or 1 in line „LC“.
Programming lock disabled
Programming lock enabled
Programming lock means programming lines are read only which will
be signaled by [dAtA] instead of [Pro] appearing in the display when
accessing programming level.
5 Technical data
Technical data - electrical ratings
Voltage supply 21...53 VAC (50/60 Hz) or
10.5...70 VDC
85...265 VAC (50/60 Hz) or
100...300 VDC
Power consumption 1.8 W
Display LED, 7-segment display (with 60 unit
stickers for front)
Number of digits 4-digits
Digit height 10 mm
Display range -1999...9999 („OuE“ to signal
overflow)
Display refresh 250 ms
A/D transformer Principle ∑∆
Resolution 16 bit
Measuring rate 20/s
Measuring accuracy ±(0.1 % +3 digit)
Temp. coeffic. 100 ppm/°C
Analog input Current or voltage input
Programmable Measuring range
parameters Display range can be linearised
Decimal point
Data memory >10 Jahre in EEPROM
Standard Protection class II
DIN EN 61010-1 Overvoltage category II
Pollution degree 2
Emitted interference DIN EN 61000-6-3
Interference immunity DIN EN 61000-6-2