Before you begin programming homelink, Programming a rolling code – Dodge 2015 Dart - User Guide User Manual

Page 96

Before You Begin Programming HomeLink®

Ensure that your vehicle is parked outside of the garage before you begin programming.

For efficient programming and accurate transmission of the radio-frequency signal, it is
recommended that a new battery be placed in the hand-held transmitter of the device that
is being programmed to the HomeLink

system.

To erase the channels, place the ignition switch into the ON/RUN position, then push and
hold the two outside HomeLink

buttons (I and III) for up to 20 seconds or until the red

indicator flashes.

NOTE:
Erasing all channels should only be performed when programming HomeLink

for the first

time. Do not erase channels when programming additional buttons.

If you have any problems, or require assistance, please call toll-free 1-800-355-3515 or,
on the Internet at HomeLink.com for information or assistance.

Programming A Rolling Code

For programming Garage Door Openers that were manufactured after 1995. These Garage
Door Openers can be identified by the LEARN or TRAIN button located where the hanging
antenna is attached to the Garage Door Opener. It is NOT the button that is normally used
to open and close the door. The name and color of the button may vary by manufacturer.
1. Place the ignition switch into the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink

button you wish to program while keeping the HomeLink

indicator light in view.

3. Push and hold the HomeLink

button you want to program while you push and hold

the hand-held transmitter button.

4. Continue to hold both buttons and observe the indicator light. The Homelink

indicator will flash slowly and then rapidly after Homelink

has received the frequency

signal from the hand-held transmitter. Release both buttons after the indicator light
changes from slow to rapid.

5. At the garage door opener motor (in the garage), locate the LEARN or TRAINING

button. This can usually be found where the hanging antenna wire is attached to the
garage door opener motor. Firmly press and release the LEARN or TRAINING button.

NOTE:
You have 30 seconds in which to initiate the next step after the LEARN button has been
pressed.
6. Return to the vehicle and press the programmed HomeLink

button twice (holding the

button for two seconds each time). If the device is plugged in and activates,
programming is complete.

E L E C T R O N I C S