Uconnect® voice command – Dodge 2015 Dart - User Guide User Manual
Page 61
Making A Phone Call
• Push the “Phone” button
.
• After the BEEP, say “dial” (or “call” a name).
Receiving A Call — Accept (And End)
• When an incoming call rings/is announced on Uconnect
®
, push the “Phone” button
.
• To end a call, push the “Phone” button
.
Mute (Or Unmute) Microphone During Call
• During a call, push the “Voice Command” button
.
• After the BEEP, say “mute” (or “mute off”).
Transfer Ongoing Call Between Handset And Vehicle
• During a call, push the “Voice Command” button
.
• After the BEEP, say “transfer call”.
Changing The Volume
• Start a dialogue by pushing the “Phone” button
, then adjust the volume during
a normal call.
• Use the radio ON/OFF VOLUME rotary knob to adjust the volume to a comfortable level
while the Uconnect
®
system is speaking. Please note the volume setting for Uconnect
®
is different than the audio system.
Uconnect® Voice Command
The Uconnect
®
Voice Command system allows you to control your AM, FM radio, satellite
radio, disc player, Uconnect
®
Phone and supported portable media devices.
When you push the “Voice Command” button
located on the steering wheel, you
will hear a beep. The beep is your signal to give a command. If you do not say a command
within a few seconds, the system will present you with a list of options. If you ever wish to
interrupt the system while it lists options, push the “Voice Command” button
,
listen for the BEEP, and say your command.
Voice Command Operation
Start a dialogue by pushing the “Voice Command” button
, you will hear a beep.
The beep is your signal to give a command. Below are a list of voice commands for each
of the different modes.
E L E C T R O N I C S
59