beautypg.com

Rear tail, stop, turn signal, side marker and, Backup lamps – Dodge 2014 Grand_Caravan - Owner Manual User Manual

Page 653

background image

1. From behind the bumper fascia, or the access panel on

the air dam, squeeze the two tabs on the side of the
bulb socket and pull straight out from the fog lamp.

CAUTION!

Do not touch the new bulb with your fingers. Oil
contamination will severely shorten bulb life. If the
bulb comes in contact with an oily surface, clean the
bulb with rubbing alcohol.

2. Disconnect the wire harness from the bulb.

3. Reconnect the wiring harness to the new bulb and

reinstall by inserting the new bulb straight into the fog
lamp until it locks into place.

Rear Tail, Stop, Turn Signal, Side Marker And
Backup Lamps

1. Raise the liftgate.

2. Remove the tail lamp assembly by removing the two

screws from the inboard side. Use a fiber stick or
similar tool to gently pry the light on the outboard side
to disengage the two ball studs.

Tail Lamp Assembly Screws

7

MAINTAINING YOUR VEHICLE

651