Dodge 2013 Challenger_SRT - User Guide - Manual (Page 114)

Component Fluid, Lubricant, or Genuine
Part
Capacities
Axle Rear– 3.6L Engine We recommend you use API
GL-5 SAE 75W140 Synthetic
Gear Lubricant.
—
Brake Master Cylinder
We recommend you use
MOPAR® DOT 3 and SAE
J1703. If DOT 3 is not avail-
able, then DOT 4 is accept-
able.
—
Power Steering Reservoir
We recommend you use
MOPAR® Hydraulic Fluid
meeting Chrysler Material
Standard MS-11655.
—
Fuel Selection– 3.6L Engine
87 Octane Acceptable.
89 Octane Recommended
19.1 Gallons (72 Liters)
(Approximate)
Fuel Selection– 5.7L Engine 91 Octane Recommended
19.1 Gallons (72 Liters)
(Approximate)
CAUTION!
• Mixing of engine coolant (antifreeze) other than specified Organic Additive Technology
(OAT) engine coolant (antifreeze), may result in engine damage and may decrease corro-
sion protection. Organic Additive Technology (OAT) engine coolant is different and should
not be mixed with Hybrid Organic Additive Technology (HOAT) engine coolant (antifreeze)
or any “globally compatible” coolant (antifreeze). If a non-OAT engine coolant (antifreeze)
is introduced into the cooling system in an emergency, the cooling system will need to be
drained, flushed, and refilled with fresh OAT coolant (conforming to MS-12106), by an
authorized dealer as soon as possible.
• Do not use water alone or alcohol-based engine coolant (antifreeze) products. Do not
use additional rust inhibitors or antirust products, as they may not be compatible
with the radiator engine coolant and may plug the radiator.
• This vehicle has not been designed for use with propylene glycol-based engine
coolant (antifreeze). Use of propylene glycol-based engine coolant (antifreeze) is not
recommended.
E-85 FLEXIBLE FUEL – (3.6L ENGINE ONLY)
• Refer to your Owner's Manual on the DVD for further details.
CAUTION!
Only vehicles with the E-85 fuel filler door label or a yellow gas cap can operate on E-85.
MAINTAINING YOUR VEHICLE
112