beautypg.com

Reprogramming a single homelink® button – Dodge 2013 Challenger - Owner Manual User Manual

Page 192

background image

4. Continue to hold buttons until the EVIC display

changes from “CHANNEL # TRAINING” to “CHAN-

NEL # TRAINED”, then release both buttons.

NOTE:

• It may take up to 30 seconds or longer in some cases

for the channel to train.

• If the EVIC displays “DID NOT TRAIN” repeat from

Step 2.

5. Press and hold the programmed HomeLink® button.

The EVIC will display “CHANNEL # TRANSMIT”. If

the device is plugged in and activates, programming is

complete.

If you unplugged the garage door opener/device for

programming, plug it back in at this time.

Reprogramming A Single HomeLink® Button
To reprogram a channel that has been previously trained,

follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink® button until

the EVIC displays “CHANNEL # TRAINING” Do not

release the button.

3. Without releasing the button proceed with

“Canadian/Gate Operator Programming” Step 2 and

follow all remaining steps.

190 UNDERSTANDING THE FEATURES OF YOUR VEHICLE