5) voice command, 6) uconnect phone, 7) menu – Ram Trucks UCONNECT 730N for Jeep User Manual
Page 24

NOTE:
If the ignition is switched OFF with the radio in
standby mode, the radio memorizes the standby state
when the ignition is switched ON again. Press the (4)
ON/OFF VOLUME rotary knob to switch the radio ON.
The navigation software is always working when the
ignition is switched ON, even if the radio is in standby
mode. It is possible to eject the CD and to display the
time if the unit is switched off.
(5) Voice Command
Press the Voice Command
hard-key (5) and
wait for the confirmation beep before you say a
voice command.
NOTE:
Some vehicles may be equipped with a Voice
Command button on the steering wheel.
(6) Uconnect
Phone
Press the Uconnect
Phone
hard-key (6) to
either activate the Uconnect
Phone system or
to cancel an active phone call.
NOTE:
• If you are in one of the navigation menus (NAV Menu,
MAP display, etc.), you need to press the Uconnect
Phone hard-key twice to end an active call.
• Some vehicles may be equipped with a Uconnect
Phone button on the steering wheel.
(7) MENU
Press the MENU hard-key (7) to access the system
settings menu.
NOTE:
Press the MENU hard-key in an active mode in
order to change mode specific settings.
12